CommandCenter Secure Gateway - Admin Guide - Version ... - Raritan

Chapter 16: Diagnostic Console
3. Type your hostname in the Host Name field. After you save, this field
will be updated to reflect the Fully-Qualified Domain Name (FQDN), if
known. See Terminology/Acronyms (on page 2) for hostname rules.
4. In the Mode field, select either Primary/Backup Mode or Active/Active
Mode. See About Network Setup (on page 182).
• In the Configuration Field, select either DHCP or Static.
• If you choose DHCP and your DHCP server has been configured
appropriately, the DNS information, the domain suffix, IP address,
default gateway, and subnet mask will be automatically populated
once you save, and you exit and re-enter Admin Console.
• If you choose Static, type an IP Address (required), Netmask
(required), Default Gateway (optional), Primary DNS (optional)
and Secondary DNS (optional), and Domain Name in Domain
Suffix (optional).
• Even if DHCP is being used to determine the IP configuration for
an interface, you must provide a properly formatted IP address
and Netmask.
5. In the Adapter Speed, select a line speed. The other values of 10, 100,
and 1000 Mbps are on a scrollable list (where only one value is visible
at any given time) and the arrow keys are used to navigate to them.
Press the Space bar to select the option displayed. For 1 GB line
speeds, select AUTO.
6. If you did not select AUTO for Adapter Speed, click Adapter Duplex
and use the arrow keys to select a duplex mode (FULL or HALF) from
the list, if applicable. While a duplex mode can be selected at any time,
it only has meaning and takes effect when Adapter Speed is not
AUTO.
7. Repeat these steps for the second network interface if you selected
Active/Active Mode.
8. Click Save. CC-SG will restart, logging out all CC-SG GUI users and
terminating their sessions. A Warning screen will appear, informing
you of the impending network reconfiguration and associated CC-SG
GUI user impact. Select to proceed.
System progress can be monitored in a Diagnostic Console Status
Screen. On the KVM port, another terminal session can be selected by
pressing Alt+F2 and logging in as status. You may return to the
original terminal session by pressing Alt+F1. There are six available
terminal sessions on F1 through F6.
246