CommandCenter Secure Gateway - Admin Guide - Version ... - Raritan

Chapter 6: Devices, Device Groups, and Ports
3. CC-SG automatically creates a virtual blade chassis and adds the
blade chassis icon in one tab. Note that a virtual blade chassis never
appears as a node in the Nodes tab.
• In the Devices tab, the virtual blade chassis device appears
beneath the KX2 device, as a virtual container to the blade
servers, which appear beneath the virtual blade chassis.
Note: If you did not configure a blade port group for the blade servers
before configuring the KX2 ports in CC-SG, you can choose Devices >
Device Manager > Launch Admin to set the blade port group. Then
configure the blade servers in CC-SG. See Configuring Slots on a Blade
Chassis Device (on page 43).
Configuring Slots on a Blade Chassis Device
If the blade servers or slots are not configured yet in CC-SG. you must
configure them by following the procedure in this section, or the blade
servers do not appear in the Devices and Nodes tabs. An Out-of-Band
KVM interface is automatically added to a blade server node.
To configure slots from the blade chassis profile:
1. In the Devices tab, click the + next to the KX2 device that is connected
to the blade chassis device.
2. Select the blade chassis device whose slots you want to configure.
3. In the Device Profile screen, select the Blades tab.
4. Select the checkbox for each slot you want to configure, and then click
OK.
To configure slots from the Configure Ports screen:
1. In the Devices tab, click the + next to the KX2 device that is connected
to the blade chassis device.
2. Select the blade chassis device whose slots you want to configure.
3. Choose Devices > Port Manager > Configure Ports.
• To configure multiple slots with the default names shown on the
screen, select the checkbox for each slot you want to configure,
and then click OK to configure each slot with the default name.
• To configure each slot individually, click the Configure button next
to the slot. Then type a name for the slot in the Port Name field,
and type a node name in the Node Name field. The default Access
Application is set according to the default application selected for
"Blade Chassis: KVM" in the Application Manager. To change it,
click the Access Application drop-down menu to select the one
you prefer from the list. Click OK to configure the slot.
43