Download Jmp User Guide

192 Output Reports Chapter 6
Using Markers
Adding Labels to Markers
When you position the arrow cursor over a point in a plot, the point’s label appears. By default, the
label is the row number. There are two ways you can customize the label:
• You can change the label so it displays values found in one or more columns instead of the row
number.
• You can enable the label to appear always, not just when you position the cursor over points.
To change the label so it displays values found in one or more columns instead of the row number:
1 In the data table, highlight the column(s) whose values you want to appear as the label in plots.
2 Select Label/Unlabel from one of the following places, as shown in Figure 6.24:
– the Cols menu in the main menu
– the red triangle icon in the columns panel
– the red triangle icon in the upper right corner of the data grid
Figure 6.24 Different Ways to Access Column Characteristic Commands
or