To Know How - GROHE

Settings
Temperature end stop:
Auromatic 2000: 34 018, 34 450, 34 692
Temperature end stop
With this thermostat fitting, the hot water end stop can
be set to between 35 °C and 45 °C.
1. Set the temperature to 20 °C.
2. Disassemble cap and temperature control handle.
Important: Regulating nut must not be adjusted.
3. Pull off red end stop and refit with the arrow pointing
to the maximum desired temperature.
4. Fit temperature control handle so that the 20 °C
marking on the handle aligns with the marking dot on
the escutcheon.
5. Install cap.
Auromatic 2000: 34 450, 34 692
Desinfection:
1. Disassemble cap.
2. Turn temperature control handle to the hot water
end stop.
3. Open shut-off valve and allow hot water at a minimum
temperature of 70 °C to run for three minutes.
4. Turn temperature control handle back to cold water
end stop and install cap.
Thermostats
Grohtherm XL: 35 085
Desinfection:
1. Unscrew and remove screw, remove cap.
2. Pull out red safety stop to the stop.
3. Turn temperature control handle to the hot water
end stop.
4. Open draw-off points and allow hot water at a
minimum temperature of 70 °C to run for three
minutes.
5. Turn temperature control handle to the cold water
end stop.
6. Press red safety stop back in.
7. Fit cap and replace screw.
8. Set temperature control handle to the desired mixed
water temperature.
T 45