May - The Monty Heat Treat News

the hardening furnace is 1750°F. Furnace is radiant tube heated with recuperators. Furnace
is currently set up for Endothermic w/Enriching Natural Gas & Air. Total BTU's for hardening
furnace is 3,180,000 BTU/HR. Tempering/Annealing Furnace; 60"W mesh belt with support
rollers. Furnace has a 35'L heating section. Four (4) zones of control with four (4) roof
mounted fans. Maximum operating temperature is 1700°F. Total BTU's for the
tempering/annealing furnace 3,790,000 BTU/HR. Includes; 5600 CFH Air Cooled
Endothermic Gas Generator, SBS Air to Oil Heat Exchanger which consists of three (3) 5
H.P. fans. Manuals & Drawings Please note that this furnace has two (2) different modes of
operation. The sequence of this furnace is as follows:
- Load parts into pre-wash dump loader
- Pre-Wash, 190°F, Gas Heat
- Parts vibrate onto cast link belt furnace
- High heat cycle
- Quench cycle, 200°F, Gas Heat, 8000 Gallon
- Wash cycle, 190°F, Gas Heat
- Temper cycle
- Oil blackening cycle
Very good condition, available immediately. Asking Price $550,000 USD.
Item #C275 CI Hayes Brazing/Sintering Furnace. Model # BAC-M 0306.536. S/N
14651. Heating section 3" high X 36" long X 6.5" wide. Mesh belt. Electrically heated
220/3/60 31.5 KW. Operating temperature of 2050F. Honeywell controller and overtemp.
Full alloy muffle. Variable speed drive. Globar heated. 9' 6" sealed water jacketed cooling
chamber. Includes nitrogen and DA flowmeters, exhaust hoods. Good condition, still
installed, complete and operational. Asking Price $15,000.00 USD
www.themonty.com
Item #C274 Cast Link Belt Line. Manufactured by Electric Furnace Company in 1955. 23"
wide belt with a hot zone of 19'. Line is complete with loading system, high heat furnace, oil
quench, temper and Endo generator. Used for neutral hardening and carburizing of
fasteners. Gas fired with an operating temperature of 1650F. Currently installed but not in