May - The Monty Heat Treat News

Item #G169 Gasbarre/Sinterite Furnace Division Endo Generator. 3000 CFH,
electrically heated 460/3/60/63 Amps/50kW. New in 2006. External dimensions of 106"
wide x 75" deep x 116" high. Controls are enclosed in a panel attached to the side of the
generator. Honeywell UDC 3200 digital temperature controller and Honeywell UDC 2500
digital high limit safety. Control switches with indicating lights are flush mounted in the
enclosure. Flange mounted fused disconnect switch for control power. Separate non fused
disconnect for the main power. Waukee flow meters are manifold mounted for incoming and
outgoing gases. Flow meters include: Natural Gas 0-1000 CFH, Air 0- 2500 CFH, (3) Mixed
Gas 0-1500 CFH and Endo 0- 3500 CFH. Step down transformer for reduced voltage to the
heating elements. Electrically heated 3 retort generator. Refractory lined shell with vertically
mounted retorts. Total of twelve (12) silicon carbide heating elements, 6 on each side are
mounted through the chamber for good uniform heating of the alloy retorts. The natural gas
and air pass through a Waukee "mixor" valve then into the Waukee gas pump. Mixed gas
enters the 3 "mixed gas" flow meters, through the Selas fire checks and enters the top of
the retorts. The gas travels through the catalyst filled heated retorts and exits at the
bottom. The exiting Endothermic gas passes through water cooled chambers then finned
cooled air heat exchangers then through the Endothermic flow meter. A pressure regulator
is supplied on the exiting gas piping. Good condition. Asking $29,500.00 USD.
Item #G165 Surface 5000 CFH Endo Generator. This gas fired endo generator has 2
retorts (both new), new brick and 3 new burners. Vendor is asking $11,000 USD or will do
a complete rebuild with Atmosphere Engineering "EndoInjector", SBS "Endotherm" and new
SSI atmosphere controllers. Also included would be new catalyst, new wiring and painting.
Price for the unit completely rebuilt would be $55,000 USD.
www.themonty.com