11.11.2014 Views

Pipelaying Tender-VOL IV - WorleyParsons.com

Pipelaying Tender-VOL IV - WorleyParsons.com

Pipelaying Tender-VOL IV - WorleyParsons.com

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

EPMC SERVICES FOR REWARI – KANPUR PIPELINE<br />

SPECIFICATION FOR PIPELINE HYDRO TESTING<br />

working order and correctly installed into the pipeline test section. Venting shall be carried out<br />

repeatedly at points in the test section where air might accumulate, e.g. at installation piping, block<br />

valves etc.<br />

The filling speed shall depend on availability of water and shall not exceed 1.8 m/s. The pressure in<br />

front of the scraper shall be carefully monitored and controlled at not less than 2bar. Depending on<br />

the elevation profile of the test section and the scrapping pressure, it may be necessary to increase<br />

the pressure at the receiver test head in order to control the scraper speed.<br />

During line filling and water treating operations, the following measurements and records shall be<br />

taken:<br />

• Inlet flow rate of line-fill water<br />

• Inlet pressure of line-fill water<br />

• Inlet temperature of line-fill water<br />

• Pressure at the receiver head<br />

• Chemical injection rates In the event of chemical injection pump failure, the filling pump shall<br />

be stopped.<br />

n:\513-mh-2145-rkpl\11 engineering\11.8 pipelines\06 spec\specification for pipeline hydrotesting\mh2145-c000-<br />

pl-spc-0011.doc<br />

MH2145-C000-PL-SPC-0011 RevA Page 36 of 71

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!