C•CURE® 800/8000 9.4 apC/8X Technical Manual - Tyco Security ...

apC/8X Panel Setup
Table 5.1: apC/8X DIP Switch Settings
Switch
Setting
(* = Default)
System Feature
S2 S2:1 a ON
OFF*
S2:2 a ON
OFF*
S2:3 a ON
OFF*
S2:6 b ON
OFF*
S2:7 ON
OFF*
S2:8 ON
OFF*
S3 S3:1 b ON
OFF*
S3:2 ON
OFF*
S3:3 b ON
OFF*
S3:4 b ON
OFF*
S3:5 b ON
OFF*
S3:6 b ON
OFF*
S3:7 ON
OFF*
S3:8 b ON
OFF*
Relay link on when door forced open
No link when door forced open
Relay link on when door held
No link when door held
Relay link on when apC/8X is offline
No link when apC/8X is offline
Reader keypad for PIN entry, if enabled
Keypad for elevator floor selection, if enabled
apC/8X ignores card misreads
apC/8X reports misreads
AUX port for local printout
AUX port for apC/8X test program
Card entry through keypad enabled
Card entry through keypad not enabled
Optional LED access pattern enabled at reader
Normal LED access pattern enabled at reader
Card numbers less than or equal to 65535 (16 bit)
Card numbers greater than 65535 (32 bit)
Activate/deactivate dates are stored
Activate/deactivate dates are not stored
Space reserved in card record for local anti-passback
No space reserved in card record for local anti-passback
Space reserved in card record for elevator control
No space reserved in card record for local elevator control
Magnetic stripe encryption used
No Magnetic stripe encryption used
Reverse card swipe signals duress
Duress alarm disabled
apC/8X Installation and Configuration Guide 5-5