Service Manual - AMS Neve

More documents

Recommendations

Info

SynchroNet ES/2 Service Manual MACHINE PARAMETERS RESERVED $109d $109f Appendix A is a list of the current parallel command routines and Appendix B is a list of the current serial command routines available. This list will be updated as machine interfaces require new action routines. If a machine cannot perform a function then the relevant table entry should be set to zero. Many of the functions will be highly machine specific and therefore are likely to be beyond the scope of most users. Issue 1 3:21
MACHINE PARAMETERS SynchroNet ES/2 Service Manual UNIFILM PARAMETERS MODE $10a0 This flag controls the unifilm output drive. If it is non zero then the FILMA FILMB outputs will be bi-phase signals, if it is zero then FILMB will be a direction signal. RESERVED $10a1 RAMPUP $10a2 This parameter controls the rate of change (increasing frequency) of the film output for tape speeds above play speed. A larger number represents a gentler ramp. A value of $00 means that the film output frequency will change abruptly to the new value. Note that the film ramp parameters control the change between different operating conditions, e.g. play to fast wind or toggle into park. When a film machine is being locked to the timeline then the usual servo parameters are used to control the film output frequency. RAMPDWN $10a3 display : RAMPDW This parameter controls the rate of change (decreasing frequency) of the film output. RESERVED $10a4/5/6 PRAMPUP $10a7 display : PRAMUP This parameter controls the rate of change of the film output when changing from stop to play. PRAMPDWN $10a8 display : PRAMDN This parameter controls the rate of change of the film output when changing from play to stop. RAMPTRM $10a9 This parameter controls the acceleration of the film ramps. It specifies the number of frames taken to transit between full ramp rate and fixed speed. If this parameter is set to $00 then a value of 4 is assumed. NEWRAMP $10aa If this parameter is set non zero then an alternative film ramp algorithm is invoked. This number is a single ramp factor which covers all four operating conditions of the above ramp factors. This parameter works in the opposite direction to the original ramp factors i.e. larger number = steeper ramp. RESERVED $10ab $10af 3:22 Issue 1
Page 1 and 2:
SynchroNet ES/2 Service Manual 527-
Page 3 and 4:
Contents SynchroNet ES/2 Service Ma
Page 5 and 6:
CIRCUIT DESCRIPTION SynchroNet ES/2
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22: CIRCUIT DESCRIPTION SynchroNet ES/2
Page 33 and 34: ES/2 TEST SOFTWARE SynchroNet ES/2
Page 53 and 54: MACHINE PARAMETERS SynchroNet ES/2
Page 71: MACHINE PARAMETERS SynchroNet ES/2
Page 81 and 82: APPENDIX A SynchroNet ES/2 Service
Page 83 and 84: APPENDIX A SynchroNet ES/2 Service
Page 85 and 86: APPENDIX B SynchroNet ES/2 Service
Page 87 and 88: APPENDIX C SynchroNet ES/2 Service
Page 89: Index SynchroNet ES/2 Service Manua
show all

Service Manual - AMS Neve

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?