SurgivetÂ® V1030 Hand-Held Pulse Oximeter

More documents

Recommendations

Info

Chapter 1: Introduction SYMBOL DEFINITION Printer icon: Parameter Alarm Printer icon: Artifact Printer icon: Small Pulse Printer icon: Check Sensor Printer icon: Searching too Long 7 Do not reuse. One use on one patient. K Moisture Sensitive 1 Not suitable for use in the presence of a flammable anesthetic mixture. D Output Voltage Connector E Input Voltage Connector G Direct Current 0 Speaker IPX2 Drip proof (monitor and dock only) < Catalog Number J H Z Collect Separately Date of Manufacture Manufacturer This product contains electrical and electronic components (including batteries) that may contain materials, which if disposed of with general waste, could be damaging to the environment. In accordance with Directive 2002/96/EC Waste Electrical and Electronic Equipment, residents of the European Union must follow specific disposal or recycling instructions for this product. Contact your local distributor, or visit the following web site for specific instructions: http://www.smiths-medical.com/recycle/index.html Non-European Union residents must dispose of or recycle this product (including batteries) in accordance with the local laws or regulations that apply. 1-2 Veterinary V1030 Hand-Held Pulse Oximeter Operation Manual
Chapter 1: Introduction KEYWORD WARNING CAUTION NOTE Warnings DEFINITION Something that could hurt the patient or hurt the operator. Something that could damage the monitor. Other important information. WARNING! The monitor was not designed or tested to be an apnea monitor. WARNING! Do not use this device in the presence of flammable anesthetics. WARNING! Do not use this device in the presence of magnetic resonance imaging (MR or MRI) equipment. WARNING! Operation of this device may be adversely affected in the presence of conducted transients or strong electromagnetic (EM) or radiofrequency (RF) sources, such as portable and mobile RF communication equipment, electrosurgery and electrocautery equipment, x-rays, and high intensity infrared radiation. WARNING! Operation of this device may be adversely affected in the presence of computed tomograph (CT) equipment. WARNING! Any monitor that has been dropped or damaged should be inspected by qualified service personnel, prior to use, to insure proper operation. WARNING! If the accuracy of any measurement is in question, verify the patient’s vital signs by an alternative method, and then check the monitor for proper functioning. WARNING! This device must be used in conjunction with clinical signs and symptoms. This device is only intended to be an adjunct in patient assessment. WARNING! This device is intended for use by persons trained in veterinary health care. The operator must be thoroughly familiar with the information in this manual before using the device. WARNING! It is the operator’s responsibility to set alarm limits appropriately for each individual patient. WARNING! Prolonged use or the patient’s condition may require changing the sensor site periodically. Change sensor site and check skin integrity, circulatory status, and correct alignment at least every 4 hours. WARNING! Use only SpO 2 sensors supplied with, or specifically intended for use with, this device. WARNING! Incorrectly applied sensors may give inaccurate readings. f Refer to the sensor insert for proper application instructions. WARNING! Do not autoclave, ethylene oxide sterilize, or immerse the sensors in liquid. This may cause damage to the sensor which may cause inaccurate readings. WARNING! Unplug the sensor from the oximeter before cleaning or disinfecting to prevent damaging the sensor or monitor, and to prevent user safety hazards. Veterinary V1030 Hand-Held Pulse Oximeter Operation Manual 1-3
Page 1: Surgivet® V1030 Hand-Held Pulse Ox
Page 4 and 5: Table of Contents Pulse Oximeter Se
Page 6 and 7: Table of Contents Pulse Rate.......
Page 8 and 9: Warranty and Service Information Li
Page 12 and 13: Chapter 1: Introduction WARNING! Me
Page 14 and 15: Chapter 1: Introduction WARNING! Do
Page 16 and 17: Chapter 1: Introduction Notes NOTE:
Page 18 and 19: Chapter 2: Intended Use and Monitor
Page 20 and 21: Chapter 3: Controls and Features Ch
Page 22 and 23: Monitor Operating Keys Chapter 3: C
Page 24 and 25: Chapter 4: Operating Instructions C
Page 26 and 27: Installing the Batteries Chapter 4:
Page 28 and 29: AC Power Plug the AC power supply i
Page 30 and 31: Chapter 4: Operating Instructions A
Page 32 and 33: Chapter 4: Operating Instructions F
Page 34 and 35: Chapter 4: Operating Instructions W
Page 36 and 37: Chapter 5: Changing the Monitor’s
Page 42 and 43: Factory Defaults Chapter 5: Changin
Page 44 and 45: Chapter 6: Alarms High Priority Ala
Page 46 and 47: Chapter 6: Alarms TYPE DISPLAY INDI
Page 48 and 49: Chapter 6: Alarms saving changes, w
Page 50 and 51: Chapter 8: Optional Docking Station
Page 52 and 53: WW1090 Lithium-Ion (Li+) Rechargeab
Page 54 and 55: Attaching the Printer Chapter 8: Op
Page 56 and 57: Choosing the Print Mode Chapter 8:
Page 58 and 59: Chapter 9: PC Communication Setup C
Page 60 and 61:
Output Format Chapter 9: PC Communi
Page 62 and 63:
Chapter 10: Maintenance CAUTION! Di
Page 64 and 65:
Chapter 11: Troubleshooting Power P
Page 66 and 67:
Chapter 11: Troubleshooting PROBLEM
Page 68 and 69:
Chapter 11: Troubleshooting This pa
Page 70 and 71:
Chapter 12: Optional Supplies and A
Page 72 and 73:
Chapter 13: Specifications SpO 2 Sp
Page 74 and 75:
Chapter 13: Specifications Power Re
Page 76 and 77:
Chapter 13: Specifications This pag
Page 78 and 79:
Appendix A: Guidance and Manufactur
Page 80 and 81:
Page 82 and 83:
Page 84:
Appendix B: SpO 2 and Pulse Rate -
show all

SurgivetÂ® V1030 Hand-Held Pulse Oximeter

Create successful ePaper yourself

Delete template?

Save as template?