Surgivet® V1030 Hand-Held Pulse Oximeter

Chapter 8: Optional Docking Station and Printer
Loading Paper
The printer uses 58mm wide thermal paper. See Chapter 12: Optional Supplies & Accessories for part
number and ordering information. To load the paper, follow the steps illustrated below.
1. Release printer door by lifting clear
cover.
Lift here
Figure 8-6A: Release Printer Door
2. Swing open paper holder by continuing
to pull on clear door.
3. Remove existing spool if present.
Figure 8-6B: Swing Open Paper Holder
4. Place paper spool in holder so that the
paper exits over the top of the roll and
drapes over the rubber roller as shown
in figure 8-6C.
Figure 8-6C: Place Paper Spool in Holder
5. Close the paper holder door and the clear
cover.
6. Tear off any excess paper by pulling the
paper up toward the front of the printer.
7. The printer is now ready to use.
Figure 8-6D: Close Paper Holder Door and Clear Cover
8-6 Veterinary V1030 Hand-Held Pulse Oximeter Operation Manual