Surgivet® V1030 Hand-Held Pulse Oximeter

Chapter 5: Changing the Monitor’s Settings
Chapter 5: Changing the Monitor’s Settings
This chapter will guide the user in adjustments available from the monitor front panel. For
information on setting alarms see Chapter 6: Alarms.
NOTE: To save any changes to menu items, press the menu key ( ) or press the exit
key ( ). Allowing the menu to time out will not save any changes to the
currently displayed menu item.
Changing the Pulse Beep Volume
A “beep” tone sounds with each pulse beat. The volume of the “beep” can be adjusted to fifteen
(15) settings and off. This setting is retained at power down/power up.
To adjust the volume to the “off” setting, press and hold the down arrow (o). From the “off”
setting, set the volume by pressing the up arrow (n). The volume is changed with each key press.
Setup Menu
Enter the Setup Menu by pressing and holding the Exit key ( ) and then pressing the Menu key
( ). Each subsequent press of the Menu key allows a different setting to be changed using the
up and down arrow keys (no). The items to be changed appear in the order of the list below.
Each parameter will have a label shown on the display. See the sections that follow for details. All
of the settings in the Setup Menu are retained at power down/power up.
The setup menu allows adjustment of the following options:
• SpO 2 and Pulse Rate Averaging
• High Sensitivity Mode
• Display Brightness
• Year
• Month
• Day
• Hours
• Minutes
• Restore Defaults
To exit any menu, press the Exit key (
) or wait 20 seconds.
Veterinary V1030 Hand-Held Pulse Oximeter Operation Manual 5-1