Connection to the SysKonnect SK-54P1 802.11g Wireless Print Server

8 Web-Based Management
SysKonnect SK-54P1 802.11g Wireless Print Server
This chapter explains how to use your web browser to configure the SysKonnect SK-54P1
802.11g Wireless Print Server.
Overview
The SysKonnect SK-54P1 802.11g Wireless Print Server incorporates the HTTP server. This
allows you to connect to the SysKonnect SK-54P1 802.11g Wireless Print Server and configure
it using your web browser. Most browsers should work, assuming that they support tables
and forms.
Preparation
Because it supports dynamic IP address allocation using DHCP, BOOTP, or RARP (Reverse
Address Resolution Protocol), the SysKonnect SK-54P1 802.11g Wireless Print Server ships
with an IP address of 0.0.0.0.
This is not a valid IP address.
Therefore, you must do one of the following:
• Check your DHCP server (if you have one), and determine the IP address allocated to
the SysKonnect Print Server.
• Use the diagnostic button (if fitted) to print a report which includes the current IP address.
(Press the diagnostic button, and hold it for 2 seconds.)
• Use the Setup Wizard, BiAdmin or another SysKonnect Print Server utility to allocate a
valid IP address to the SysKonnect Print Server.
• Add an entry to the arp table to associate the hardware address of the SysKonnect Print
Server with the desired IP address, as follows:
arp -s IP_Address 00:c0:02:xx:xx:xx (Unix)
arp -s IP_Address 00-c0-02-xx-xx-xx (Windows)
where:
IP_Address is the IP address you wish to assign to the SysKonnect Print Server.
00:c0:02:xx:xx:xx is the hardware address of the SysKonnect Print Server.
(The hardware address of the SysKonnect SK-54P1 802.11g Wireless Print Server is
shown on a sticker on the base of the device.)
Example Unix:
arp -s 192.168.0.21 00:c0:02:12:34:56
Example Windows:
arp -s 192.168.0.21 00-c0-02-12-34-56