XProtect Express 1.1; Administrator's Manual - Milestone

Milestone XProtect ® Express 1.1Administrator's ManualNameLive Frame RateRecording Frame RateDescriptionRequired average frame rate for live video from the camera. Select numberof frames, then select the time unit interval (second, minute or hour).If the camera supports dual stream and dual stream is enabled, the LiveFrame Rate column will be read-only with the value Dual streaming—which cannot be altered.Required average frame rate for recorded video from the camera. Selectnumber of frames, then select the time unit interval (second, minute orhour). The frame rate must be higher than the frame rate specified undernormal mode.Speedup frame rate mode:NameEnable speedup frame rateFrame RateLive Frame RateRecording Frame RateOn motionOn eventDescriptionThe speedup feature lets you use a higher than normal frame rate if motionis detected and/or an event occurs. When you enable speedup, furthercolumns for specifying speedup details become available.Speedup frame rate for viewing video from the camera. Select number offrames, then select the time unit interval (second, minute or hour). Theframe rate must be higher than the frame rate specified under normalmode.Required average frame rate for live video from the camera. Select numberof frames, then select the time unit interval (second, minute or hour). Theframe rate must be higher than the frame rate specified under normalmode.If the camera supports dual stream and dual stream is enabled, the LiveFrame Rate column will be read-only with the value Dual streaming—which cannot be altered.Required average frame rate for recorded video from the camera. Selectnumber of frames, then select the time unit interval (second, minute orhour). The frame rate must be higher than the frame rate specified undernormal mode.Select this check box to use the speedup frame rates when motion isdetected. The camera will return to the normal frame rates two secondsafter the last motion is detected.Select this check box to use the speedup frame rates when an eventoccurs and until another event occurs. Use of speedup on event requiresthat events (see "Overview of events and output" on page 111) have beendefined, and that you select start and stop events in the neighboring lists.Start EventStop EventTip: If you have not yet defined any suitable events, you can quickly do it:Use the Configure events list, located below the other fields.Select required start event. The camera will begin using the speedup framerates when the start event occurs.Select required stop event. The camera will return to the normal framerates when the stop event occurs.Tip: Speedup does not necessarily have to be based on motion- or events, you can also use scheduling (see"Speedup" on page 127) to configure speedup based on particular periods of time. If you prefer such time-basedspeedup, you should still enable the use of speedup by selecting the Enable speedup check box.www.milestonesys.com 92 Advanced configuration