XProtect Express 1.1; Administrator's Manual - Milestone

Milestone XProtect ® Express 1.1Administrator's ManualNameEnable dedicated live streamStreamResolutionFPSDescriptionThis additional stream feature lets you use the alternative stream of thecamera. It enables two independent streams to the recording server—astream for live viewing and another stream for recording purposes, withdifferent resolution, encoding, and frame rate.Select the type of the live stream. Stream settings for viewing live videoand for recording video may very well be different in order to get the bestresult.Select the resolution of the camera.Select the camera's live frame rate per second (FPS)If the camera uses the MJPEG video formatWith MJPEG, you can define frame rates for regular as well as speedup modes. Furthermore, if the camera offersdual stream, you can enable this:Regular Frame Rate Mode:NameFrame RateDescriptionRequired average frame rate for video from the camera. Select number offrames, then select the time unit interval (second, minute or hour).Speedup Frame Rate Mode:NameEnable speedup frame rateFrame RateOn motionOn eventDescriptionThe speedup feature lets you use a higher than normal frame rate if motionis detected and/or an event occurs. When you enable speedup, furthercolumns for specifying speedup details become available.Speedup frame rate for viewing video from the camera. Select number offrames, then select the time unit interval (second, minute or hour). Theframe rate must be higher than the frame rate specified under normalmode.Select this check box to use the speedup frame rates when motion isdetected. The camera will return to the normal frame rates two secondsafter the last motion is detected.Select this check box to use the speedup frame rates when an eventoccurs and until another event occurs. Use of speedup on event requiresthat events (see "Overview of events and output" on page 111) have beendefined, and that you select start and stop events in the neighboring lists.Tip: If you have not yet defined any suitable events, you can quickly do it:Use the Configure events list, located below the other fields.Start EventStop EventSelect required start event. The camera will begin using the speedup framerates when the start event occurs.Select required stop event. The camera will return to the normal framerates when the stop event occurs.www.milestonesys.com 94 Advanced configuration