Wireless Ad Hoc and Sensor Networks

More documents

Recommendations

Info

Distributed Power Control and Rate Adaptation 243(Jung and Vaidya 2002), is used to overcome the hidden-terminal problemand it is combined with the proposed power control scheme.The proposed MAC protocol uses the novel DPC algorithm to calculatethe transmitter power for every MAC frame, whereas the other protocols(Jung and Vaidya 2002, Gomez et al. 2001) modify the power only for theDATA and ACK frames. Additionally, the algorithm predicts the channelstate for the next transmission, whereas the other protocols use the oldmeasurements to select a power value. Finally, a safety factor is utilizedto adjust the transmission power in the case of delayed feedback. Thus,the proposed power control MAC protocol selects a more suitable transmissionpower for fading channels whereas others do not. Moreover, thetrain of pulses is used for every MAC frame including the RTS and CTS,whereas the protocol in Jung and Vaidya (2002) applies it to DATA framesonly. Consequently, the proposed approach, as explained in the followingsubsection, results in higher channel utilization and energy efficiency.6.5.1 Hidden-Terminal ProblemThe hidden-terminal problem occurs in a wireless network when a thirdnode causes a collision with an ongoing communication between any twonodes. The problem is illustrated in Figure 6.2, where node A transmitsdata to node B. Node F is outside the sensing range of transmitter A, andit will not detect transmission of the DATA frame that is sent from node A.Sensing range of Afor DPC powerTransmissionrange of Afor DPC powerSensing range of Afor MAX powerTransmissionrange of Afor MAX power“new”hiddenterminals’area“Improvement”areaCAGBF“802.11”hiddenterminals’areaCollisionrange of BFIGURE 6.2Hidden-terminal problem in ad hoc networks.
244 Wireless Ad Hoc and Sensor NetworksNAV (G)(no pulses)Tx powerG does not sense any signal,starts transmission, whichcauses collision with (A->B)MaxDPC levelRTS CTSDATATimeACKFIGURE 6.3Transmission using DPC.Therefore, F can initiate transmission, which will collide with DATA frameat the receiving node B. In Figure 6.2, nodes located inside a markedregion, called “hidden terminals’ area,” are potential sources for this problem.The DPC schemes, generally, use much lower power for the transmissionof frames, and therefore result in increased collisions, as shownin Figure 6.3. A solution similar to that found in other schemes (Jung andVaidya 2002) is proposed.Generally, when a lower transmission power is used, the transmissionand sensing range of a node will decrease as shown in Figure 6.2. NodeG will fail to detect transmission from node A and it will initiate transmissionby assuming that the channel is idle. If node G uses maximumpower, then a collision will occur at receiver node B. Hence, the probabilityof hidden-terminal problem occurring in the network will increase whena low transmitter power is used.To overcome this problem, in our proposed methodology, a train ofshort pulses with increased transmitted power, periodically, is used duringtransmission. The RTS, CTS, DATA, and ACK frames are transmittedusing the power dictated by the proposed DPC, along with the train ofpulses. The pulses use maximum transmission power defined for thenetwork. This ensures that all the nodes in the sensing range of thetransmitter will detect the pulses and update their NAV vectors accordingly.Thus, the nodes in the sensing range of the transmitter node willnot cause collision. Figure 6.3 and Figure 6.4 display the difference inhandling of NAV vector in the available DPC schemes with and withoutthe train of pulses.The generation of the train of pulses should be implemented in thehardware. In details, the circuitry of RF amplifier should periodicallyincrease the transmission power for every transmission. Additionally, thissolution is simpler to implement than the one proposed in Jung andVaidya (2002), because an amplifier module in this scheme does not needto know the type of a transmitted frame.
Page 2 and 3:
Wireless Ad Hocand SensorNetworksPr
Page 4:
18. Chaos in Automatic Control, edi
Page 7 and 8:
CRC PressTaylor & Francis Group6000
Page 10 and 11:
Table of Contents1 Background on Ne
Page 12 and 13:
3 Congestion Control in ATM Network
Page 14 and 15:
5.4.2 Distributed Power Controller
Page 16 and 17:
7.3 Adaptive and Distributed Fair S
Page 18:
9.2.2 Overview.....................
Page 21 and 22:
the number of connections in each l
Page 23 and 24:
y Maheswaran Thiagarajan, and tirel
Page 25 and 26:
2 Wireless Ad Hoc and Sensor Networ
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
10 Wireless Ad Hoc and Sensor Netwo
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 72 and 73:
2BackgroundIn this chapter, we prov
Page 74 and 75:
Background 51u(k)x n (k + 1)x n (k)
Page 76 and 77:
Background 53with x( 0)being the in
Page 78 and 79:
Background 55with tr(.) the matrix
Page 80 and 81:
Background 57nGiven a function ft (
Page 82 and 83:
Background 592.3.2 Lyapunov Stabili
Page 84 and 85:
Background 61as well as Jagannathan
Page 86 and 87:
Background 63The subsequent example
Page 88 and 89:
Background 65Evaluating this along
Page 90 and 91:
Background 67Now, select the feedba
Page 92 and 93:
Background 69is SISL if and only if
Page 94 and 95:
Background 71L 1 (x)L(x, t)L 0 (x)0
Page 96 and 97:
Background 73for some R > 0 such th
Page 98 and 99:
Background 75Evaluating the first d
Page 100:
Background 77Section 2.4Problem 2.4
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
100 Wireless Ad Hoc and Sensor Netw
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 170 and 171:
4Admission Controller Design for Hi
Page 172 and 173:
Admission Controller Design for Hig
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216: 192 Wireless Ad Hoc and Sensor Netw
Page 265: 242 Wireless Ad Hoc and Sensor Netw
Page 317 and 318:
Page 319 and 320:
Page 321 and 322:
Page 323 and 324:
Page 326 and 327:
7Distributed Fair Scheduling in Wir
Page 328 and 329:
Distributed Fair Scheduling in Wire
Page 330 and 331:
Page 332 and 333:
Page 334 and 335:
Page 336 and 337:
Page 338 and 339:
Page 340 and 341:
Page 342 and 343:
Page 344 and 345:
Page 346 and 347:
Page 348 and 349:
Page 350 and 351:
Page 352 and 353:
Page 354 and 355:
Page 356 and 357:
Page 358 and 359:
Page 360 and 361:
Page 362 and 363:
Page 364 and 365:
Page 366 and 367:
Page 368 and 369:
Page 370 and 371:
Page 372 and 373:
Page 374 and 375:
Page 376 and 377:
Page 378 and 379:
Page 380 and 381:
8Optimized Energy and Delay-Based R
Page 382 and 383:
Optimized Energy and Delay-Based Ro
Page 384 and 385:
Page 386 and 387:
Page 388 and 389:
Page 390 and 391:
Page 392 and 393:
Page 394 and 395:
Page 396 and 397:
Page 398 and 399:
Page 400 and 401:
Page 402 and 403:
Page 404 and 405:
Page 406 and 407:
Page 408 and 409:
Page 410 and 411:
Page 412 and 413:
Page 414 and 415:
Page 416 and 417:
Page 418 and 419:
Page 420 and 421:
Page 422 and 423:
Page 424 and 425:
Page 426 and 427:
Page 428 and 429:
Page 430 and 431:
Page 432 and 433:
Page 434 and 435:
Page 436 and 437:
Page 438 and 439:
Page 440 and 441:
Page 442 and 443:
Page 444 and 445:
Page 446 and 447:
Page 448 and 449:
Page 450 and 451:
Page 452 and 453:
9Predictive Congestion Control for
Page 454 and 455:
Predictive Congestion Control for W
Page 456 and 457:
Page 458 and 459:
Page 460 and 461:
Page 462 and 463:
Page 464 and 465:
Page 466 and 467:
Page 468 and 469:
Page 470 and 471:
Page 472 and 473:
Page 474 and 475:
Page 476 and 477:
Page 478 and 479:
Page 480 and 481:
Page 482 and 483:
Page 484 and 485:
10Adaptive and Probabilistic Power
Page 486 and 487:
Adaptive and Probabilistic Power Co
Page 488 and 489:
Page 490 and 491:
Page 492 and 493:
Page 494 and 495:
Page 496 and 497:
Page 498 and 499:
Page 500 and 501:
Page 502 and 503:
Page 504 and 505:
Page 506 and 507:
Page 508:
Page 511 and 512:
Page 513 and 514:
Page 515 and 516:
Page 517 and 518:
Page 519 and 520:
Page 521 and 522:
Page 523 and 524:
Page 525 and 526:
Page 527 and 528:
Page 529 and 530:
Page 531 and 532:
Page 533 and 534:
Page 535 and 536:
Page 537:
show all

Wireless Ad Hoc and Sensor Networks

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?