12.07.2015 Views

twin-path® slings in action - Hanes Supply, Inc

twin-path® slings in action - Hanes Supply, Inc

twin-path® slings in action - Hanes Supply, Inc

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

cordage InformationYOUR SLING AND RIGGING SPECIALISTSelect the Correct SizeA rope too small may fail quickly, one too large will prove expensive. Don't work any ropeabove one-fifth of its break<strong>in</strong>g strength.Avoid OverloadsSafe work<strong>in</strong>g load ranges for any new rope is between 1/5 and 1/12 of its m<strong>in</strong>imum tensile.Make enough allowances for safety if your rope is old or worn. Ignor<strong>in</strong>g this safety factorcauses early rope replacement and is dangerous to men and materials.Keep Away from ChemicalsAcids & Alkalis are <strong>in</strong>jurious to rope. If exposed, wash thoroughly and <strong>in</strong>spect before us<strong>in</strong>g.Watch for battery and build<strong>in</strong>g clean<strong>in</strong>g acids, caustic soda and pa<strong>in</strong>t. Keep rats away.Stop Unnecessary WearOuter and <strong>in</strong>ner rope fibers contribute equally to the strength of your rope. If worn out, therope is naturally weakened. Elim<strong>in</strong>ate rubb<strong>in</strong>g, dragg<strong>in</strong>g or work<strong>in</strong>g over rough surfaces.Protect its surface with chaf<strong>in</strong>g gear, such as canvas wrapped and tied around the rope.Pad corners of sharp objects when lift<strong>in</strong>g, and avoid stra<strong>in</strong> on sharp bends. Remove k<strong>in</strong>ksif they form.To Uncoil RopeA new coil of rope should be placed flat on its side with the "tag" <strong>in</strong>side end down. Removethe outside lash<strong>in</strong>gs and unfasten the <strong>in</strong>side bands. Leave burlap around the coil to keeprope clean.Reach down through the eye of coil and pull out the <strong>in</strong>side end, where tag is attached,through the eye of the coil.Store it ProperlyKeep <strong>in</strong> dry, cool place with good air circulation. Use wooden grat<strong>in</strong>g on concrete or steelfloors, and keep away from steam pipes and metal walls. Protect from prolonged exposureto sunlight. Store only clean, dry rope.Use Right SheavesBlock sizes or sheaves should be eight times the diameter of the rope. For power transmissionor for use with cont<strong>in</strong>uous load, sheaves should be at least forty times the diameter ofthe rope. Small sheaves cause added friction and rope wear. Keep sheaves smooth.Watch Rope ConditionInspect rope frequently, whether work<strong>in</strong>g or <strong>in</strong> storage. Occasionally reverse your rope,end-to-end, to distribute the wear more evenly.Use worn rope only where strength failure will not cause <strong>in</strong>jury or damage.*All ropes will last longer if given proper care and handl<strong>in</strong>g, storage and use.These are the more important po<strong>in</strong>ts to keep <strong>in</strong> m<strong>in</strong>d to assure greatest service and safety.HEADQUARTERS: 55 James E. Casey Drive • Buffalo, NY 14206 PHONE: 716.826.2636 FAX: 716.826.4412 www.hanessupply.com69

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!