Heavy Duty Balanced Opposed Compressors
Heavy Duty Balanced Opposed Compressors
Heavy Duty Balanced Opposed Compressors
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
FOR MODELS: JG AND JGA SECTION 4 - LUBRICATION AND VENTING<br />
2 Disconnect wiring and loosen set screws. Remove DNFT housing to a safe<br />
atmosphere.<br />
3 Use 3/8 inch ratchet wrench to remove the pipe plug.<br />
4 Remove battery from the DNFT and disconnect from the polarized connector.<br />
5 Connect the new battery (Ariel part number A-10807 or Radio Shack 960-0418)<br />
to the attached polarized plug.<br />
6 Reinsert the battery and reinstall pipe plug.<br />
7 Replace DNFT control housing on the magnet housing to original position and<br />
tighten set screws. Reattach wiring and conduit.<br />
8 Verify the DNFT is working by pre-lubing the system and check for LED blink<br />
See the Ariel web site - vendor literature - Whitlock for more details on DNFT’s.<br />
MAGNET<br />
HOUSING<br />
MAGNET<br />
O-RING<br />
CONTROL HOUSING<br />
HEAD<br />
ALLEN<br />
SCREWS(2)<br />
SET<br />
SPACER<br />
POLARIZED CONNECTOR<br />
FIGURE 4-5: DIGITAL NO-FLOW TIMER SWITCH - (DNFT)<br />
Assembly Instructions For Divider Valves<br />
LED<br />
NOTE: THE CENTER TIE ROD IN THE BASEPLATE IS OFFSET SO THAT THE INTER-<br />
MEDIATE BLOCKS CANNOT BE ASSEMBLED BACKWARDS. IF EXCESSIVE<br />
FORCE IS ENCOUNTERED DURING ASSEMBLY, MAKE SURE BLOCK IS NOT<br />
BACKWARDS.<br />
1. Screw three tie rods into inlet block until ends are flush with surface of block.<br />
2 Slide inlet gasket onto tie rods.<br />
3 Alternately slide an intermediate block and an intermediate gasket plate onto the<br />
tie rods until the last intermediate block is in place.<br />
4 Discard remaining intermediate gasket plate.<br />
5 Slide end gasket plate and end block onto tie rods.<br />
6 Lay baseplate assembly on flat surface and tightening nuts to 72 lb-in. (8.1<br />
N·m), torque.<br />
7 Mount divider valves with gasket plates onto baseplate and tightening mounting<br />
screws to 108 lb-in. (12.2 N·m), torque.<br />
PAGE 4 - 16 11/01<br />
SPRING<br />
REPLACEABLE<br />
FIELD<br />
BATTERY<br />
ARIEL P/N:A-10807<br />
#22 AWG 18" LEADS (7)<br />
RED<br />
RED<br />
ORANGE<br />
GREEN<br />
ORANGE<br />
YELLOW<br />
YELLOW<br />
1/2“ PIPE PLUG