Heavy Duty Balanced Opposed Compressors

More documents

Recommendations

Info

FOR MODELS: JG AND JGA SECTION 4 - LUBRICATION AND VENTING Oil Tubing From Frame Gallery to Top and Bottom of Guide to Lubricate Crosshead Lube Oil Inlet to Cast-In Oil Gallery. Oil flows to the Crankshaft Main Bearings and thru Drilled Holes in the Crankshaft to Connecting Rod Bearings. From there, thru Drilled Holes in the Connecting Rods to the Crosshead Pins and Bearings. Customer Lines Lube Oil Pump Lube Oil Cooler Lube Oil Strainer Piping By Ariel Thermostatic Control Valve FIGURE 4-11: LUBE OIL SYSTEM SCHEMATIC - TYPICAL Hand - Priming Pump Customer Lines Check Valve PAGE 4 - 24 11/01 B A C Filter Inlet
FOR MODELS: JG AND JGA SECTION 4 - LUBRICATION AND VENTING Lube Oil Strainer, Filter & Filter Installation Instructions Lube Oil Strainer The strainer is located on the auxiliary end of the crankcase below the oil level. The strainer basket should be taken out and washed in an appropriate solvent whenever the lubricating oil is changed. Lube Oil Filter Ariel recommends replacing filter element when differential pressure reaches approximately 10 PSI (70 kPa) across the filter at normal operating temperatures or at six month intervals. Filter Element Installation Instructions 1. Clean filter base surface, and be certain old gasket is removed. 2 Fill filter with clean oil using the same grade oil as in the crankcase. 3 Apply clean lube oil to the filter gasket. 4 After the filter gasket contacts the base, tighten one turn. 5 After starting the unit, check for leaks, and retighten if necessary. 6 Do not run unit with a damaged filter can. It can fracture or leak. Replace only with an Ariel approved filter. NOTE: FAILURE TO FILL FILTER VESSEL WITH OIL, PRIOR TO STARTING, CAN CAUSE SEVERE DAMAGE TO THE COMPRESSOR. Lube Oil Pump & Lube Oil Pressure Discharge Suction Remove Cap to Expose Adjusting Screw (Loosen Locknut and Turn Screw Clockwise to Increase Pressure) FIGURE 4-12: LUBE OIL PUMP - JG:A/2 11/01 PAGE 4 - 25
Page 1 and 2:
ARIEL Heavy Duty Balanced Opposed C
Page 3 and 4:
FOR MODELS: JG AND JGA TABLE OF CON
Page 5 and 6:
FOR MODELS: JG AND JGA TABLE OF CON
Page 7 and 8:
FOR MODELS: JG AND JGA SECTION 1 -
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20: FOR MODELS: JG AND JGA SECTION 1 -
Page 69: FOR MODELS: JG AND JGA SECTION 4 -
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
show all

Heavy Duty Balanced Opposed Compressors

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?