IBM Tivoli Storage Manager for UNIX and Linux Backup-Archive ...

Table 6. UNIX and Linux client installation reference (continued)Installation instructions“Installing the Linux on POWER client” on page 22“Installing the Linux x86/x86_64 client” on page 25“Installing the Linux for zSeries client” on page 27“Installing the Mac OS X client” on page 29“Installing the Solaris clients” on page 35For information on Installing the z/OS UNIX System Services Client, see theprogram directories on the following Web site:http://www.ibm.com/software/sysmgmt/products/support/IBMTivoliStorageManager.htmlPage“Installingthe Linux onPOWERclient” onpage 22“Installingthe Linuxx86/x86_64client” onpage 25“Installingthe Linuxfor zSeriesclient” onpage 27“Installingthe Mac OSX client” onpage 29“Installingthe Solarisclients” onpage 35Related conceptsChapter 2, “Configuring the Tivoli Storage Manager client,” on page 41After successfully installing the Tivoli Storage Manager client, you must configurethe client before performing any operations.Installing the AIX clientWith Tivoli Storage Manager 6.1.0 AIX, you can use both 32-bit and 64-bit clients.However, only one client can be installed at a time. If you install both the 32-bitand 64-bit clients at the same time, you receive an error message.If you are moving from a 32-bit client to a 64-bit client, first remove the 32-bitclient using SMIT (tivoli.tsm.client.ba). Then install the 64-bit client(tivoli.tsm.client.ba.64bit).If you use the 64-bit client, you must also install the 64-bit version of the API(tivoli.tsm.client.api.64bit). The 32-bit API (tivoli.tsm.client.api.32bit) is installed atthe same time, and can coexist with the 64-bit API.If the 64-bit client is installed but you want to use the 32-bit client instead, youmust remove the 64-bit client. Use SMIT to remove the 64-bit client(tivoli.tsm.client.ba.64bit), and then install the 32-bit client. You do not need touninstall the 64-bit API.Chapter 1. Installing the Tivoli Storage Manager clients 15