12LS Controller Installation and Operation Manual, Rev 3 ... - Watlow

Data Boundary ErrorThis Error Code is returned when:- A Read command attempts to read beyond the 32 byteboundary of byte-size variables- A Read command attempts to read beyond the 64 byteboundary of word-size variables- A Read command is received that specifies the numberof bytes to read as 0- AWritecommand attempts to write beyondthe32 byteboundary of byte-size variables- A Write command attempts to write beyond the 64 byteboundary of word-size variables. Data Table AddressesAddressesVariable Number Size Hex Byte Range Octal Word Range-------- ------ ---- -------------- ----------------Prop. Gain 32 Byte 0100 - 011F 200 - 217Rate 32 Byte 0120 - 013F 220 - 237Reset 32 Byte 0140 - 015F 240 - 257Input Type 32 Byte 0160 - 017F 260 - 277Output Value 32 Byte 0180 - 019F 300 - 317Output Type 32 Byte 01A0 - 01BF 320 - 337Output Filter 32 Byte 01C0 - 01DF 340 - 357Cycle Time 32 Byte 01E0 - 01FF 360 - 377Alarm Deviation 32 Byte 0200 - 021F 400 - 417Setpoint 32 Word 0220 - 025F 420 - 457Measured Value 32 Word 0260 - 029F 460 - 517Ambients 08 Byte 02A0 - 02A7 520 - 523Digital I/O's 01 Byte 02A8 524Alarm Status 08 Byte 02B0 - 02B7 530 - 533Heater Check 33 Byte 02BC 536EEROM Save -- ---- 02BE 537DACQ Input Type 64 Byte 02C0 - 02FF 540 - 577DACQ Meas. Val. 64 Word 0300 - 037F 600 - 6778-2