12LS Controller Installation and Operation Manual, Rev 3 ... - Watlow

When any segment is out of tolerance for a period greater than the Tolerance Time entered, atolerance alarm is generated. A tolerance alarm activates the global annunciator output anddisplays a 'T' in the alarm status position on the display.|------------------|Display: ¦ x OUT-OF-TOLRNCE ¦¦ ALARM TIME:?hh:mm¦|------------------|x is the profile designator [A-L].The ? flashes.hh:mm is the current out-of-tolerance time limit.YESEdit the tolerance limit time.Lower display T =hh:mmUP/DOWNENTERBACKNOBACKAdjust time.Store the new setting. The display advances to Edit Ready Setpoint.Return to the SETUP R/S PROFILE? prompt.Leave tolerance time value as it is. The display advances to Edit ReadySetpoint.Return to the SETUP R/S PROFILE? prompt.4.7.4 EDIT READY SETPOINTThis menu allows editing of the ready state setpoint. This is the setpoint that will be loadedwhenever the profile is in the START (or ready) state.A profile enters START mode whenever it is first assigned to a loop. It also returns to STARTmode after completing execution.The ready setpoint provides a starting point at which segment 1 will begin.|----------------|Display: ¦ x READY SEGMENT¦¦ SETPOINT ? yyyy¦|----------------|The ? is flashing.x is the profile designator [A-L].yyyy is the current ready setpoint.YESUP/DOWNChange the ready state setpoint.Lower display SP =yyyyAdjust setpoint.4-48