12LS Controller Installation and Operation Manual, Rev 3 ... - Watlow

An example display follows:|----------------|¦05 A SEG01/07 R ¦¦TIME LEFT= 34:28¦|----------------|In this example loop 5 is running profile A. The loop is currently executing segment 1 of a total of7 segments in the profile. The total time remaining in the profile is 34:28. This could be either 34hours and 28 minutes or 34 minutes and 28 seconds.4.6.6 CYCLE COUNT DISPLAYThis display shows the profile status on the top line and the current cycle count on the bottom line.The cycle count is incremented automatically each time the profile is repeated. If (C)ontinuouscycling is selected only the current cycle number is displayed. If a specific number of cycles hasbeen specified the current cycle number and the total number to complete will be displayed.An example of the display when limited cycling has been selected is:|----------------|¦05 A SEG01/07 R ¦¦CYCLE NR= 6/12¦|----------------|In this example loop 5 is executing profile A for the 6th time. The profile will be repeated 12times.An example of the display for (C)ontinuous cycling is :|----------------|¦05 A SEG01/07 R ¦¦CYCLE NR= 123 ¦|----------------|In this example loop 5 is executing profile A for the 123rd time.4.6.7 PROFILE OPERATION MENUThis menu displays the profile status on the top line and allows for selecting certain modes ofoperation related to executing the ramp and soak profile on the bottom line.The mode selections available depend on the current status of the loop. The following tabledescribes the possible profile operations that could be performed.4-40