12LS Controller Installation and Operation Manual, Rev 3 ... - Watlow

4.7.6 EDIT EXTERNAL RESETFrom this menu one of the eight digital inputs will be selected to provide an input for a externalreset of this profile while in any of the R/S operational modes. A selection of 0 will disable thisfunction. The same input may be assigned to more than one profile.|-----------------|Display: ¦ x EXTERNAL RESET¦¦ INPUT NUMBER? d ¦|-----------------|YESThe ? is flashing.x is the profile designator [A-L].d is the assigned digital input number [1-8], 0 for noassignment-external reset disabled.Change digital input number assigned to this profile.Lower display INPUT NUMBER= dUP/DOWNENTERBACKSelect digital input number.Assign digital input number for the external reset function.Return to Setup Ramp/Soak Profile?4.7.7 EDIT SEGMENT NUMBERFrom this menu one of the twenty profile segments may be selected for editing. The defaultnumber will be either the last segment edited or SEGMENT 1 if none has been edited. Whenentering profile data sequentially the segment number will automatically increment to the nextsegment each time this menu is entered.Display:|---------------|¦ x EDIT SEGMENT¦¦ NUMBER ? yy ¦|---------------|The ? flashes.x is the profile designator [A-L].yy is the default segment number [1-20].YESSelect a segment other than the default segment for editing.Lower display SEG = xxUP/DOWNENTERBACKSelect segment number.Open selected segment for editing. Display advances to Edit Segment Time.Return to SETUP R/S PROFILE? prompt.4-50