Abbott Hospira Plum A Plus and Plum A Plus 3 version 11.6 Infusion ...

Plum A+ Infusion Systems 9- 5psig for rates between 0.1 and 0.9 mL/hr) for backpressures up to15 psig. A typical deviation under these conditions is 0.3%.Negative backpressure may affect delivery accuracy no more than2% for pressures up to -2 psig (56 inches of water). A typicaldeviation under these conditions is 0.3%.Filling Head Effect- Variations in filling head (such as containerheight) may affect delivery accuracy by no more than 2% forvariations in the range -15 to +28 inches. A typical deviation underthese conditions is 0.5%.Concurrent Delivery Effect- When both lines (A & B) are delivering,the ratio of delivery for the fluid with the lowest rate may be affectedby as much as 5% for ratios up to 9 to 1. For higher ratios, theabsolute percentage of delivery for the lowest rate may be affectedby no more than 0.5%. When air is present in the bubble trap, theabsolute percentage of delivery for the lowest rate may be affectedby up to 2.0%. When variations in container height are present, theabsolute percentage of delivery for the lowest rate may be affectedby up to 2.5% for up to 24 inches of container height differences.ENTERAL & HIGH VISCOSITY FLUIDS EFFECTSSystem delivery accuracy limits for each Enteral and High ViscosityFluid, such as those listed in the following table, can be degradedby an additional maximum of 5%. System accuracy for EnteralFluids is defined only for rates of 1 to 200 mL/hr, with no suspendedair in the solution, and using an Hospira Plum enteral set.ENTERAL/HIGH VISCOSITY FLUIDSDextrose 20% to 50% concentrationIsomil PowderSimilac PowderEnsure Plus HNTwocal HNJevity430-95215-003 (Rev. 10/05)