Prisma II High Density EDFA Modules Installation Guide
Prisma II High Density EDFA Modules Installation Guide
Prisma II High Density EDFA Modules Installation Guide
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Chapter 1Module Introduction<strong>High</strong> <strong>Density</strong> <strong>EDFA</strong> FeaturesThe high density <strong>EDFA</strong> has the following features. Front panel green light emitting diode (LED) to indicate operating status Front panel red LED to indicate alarm status SC/APC connectors Plug-and-play capability Compatible with ICIM, LCI software, and ROSA ® software Blind-mate DC power connection<strong>High</strong> <strong>Density</strong> <strong>EDFA</strong> Operation<strong>EDFA</strong> modules are single-wide, single output devices. The <strong>EDFA</strong> is monitored andcontrolled via LCI or ICIM.<strong>High</strong> <strong>Density</strong> <strong>EDFA</strong> Optical OutputLaser WarningThe optical output connectors are SC.WARNING:Avoid damage to your eyes! Do not look into any optical connector while thesystem is active. Even if the unit is off, there may still be hazardous opticallevels present.4 78-4037880-01 Rev B
Change language