Prisma II High Density EDFA Modules Installation Guide

Chapter 3Operation using ICIMOperating the ICIMUsing the ICIMOnce the module is installed, it runs without the aid of an operator. Unless alarmsare generated or your system configuration changes, you should not need to makeany adjustments to the module beyond the initial setup.To Access the ICIM LCD ContrastTo access the ICIM LCD contrast control from the MAIN menu, press theUse the key to increase or the key to decrease ICIM display contrast.key.ICIM MAIN MenuA few seconds after power-up, the MAIN menu (shown below) appears. Press thekey to select the specific option.DisplayOfflineModulesAlarmsScrollModuleShelfSlotDescriptionIndicates network management system communication status with theICIM.Indicates the number of modules in the ICIM domain.Displays the number of modules that are in alarm. Selecting this optionallows scrolling through all modules in alarm condition.Allows scrolling through all modules in the ICIM domain.Allows selection of any specific module in the ICIM domain.54 78-4037880-01 Rev B