Prisma II High Density EDFA Modules Installation Guide

Chapter 3Operation using ICIMICIM IntroductionLaser WarningWARNING:• Avoid personal injury! Use of controls, adjustments, or procedures otherthan those specified herein may result in hazardous radiation exposure.• Avoid personal injury! The laser light source on this equipment (if atransmitter) or the fiber cables connected to this equipment emit invisiblelaser radiation. Avoid direct exposure to the laser light source.• Avoid personal injury! Viewing the laser output (if a transmitter) or fibercable with optical instruments (such as eye loupes, magnifiers, ormicroscopes) may pose an eye hazard. Do not apply power to this equipment if the fiber is unmated or unterminated. Do not stare into an unmated fiber or at any mirror-like surface that could reflectlight emitted from an unterminated fiber. Do not view an activated fiber with optical instruments such as eye loupes,magnifiers, or microscopes. Use safety-approved optical fiber cable to maintain compliance with applicablelaser safety requirements. Even if the unit is off, there may still be hazardous optical levels present.ICIM FunctionThe ICIM functions as the module-user interface as well as the interface between thePrisma II modules and the network management system.The ICIM allows local module configuration and status monitoring for up to 140modules located in multiple chassis. The ICIM features easy-to-use software that canbe navigated locally on models equipped with a front-panel keypad and LCDdisplay.The ICIM can also be navigated remotely using CLI commands or the ICIM WebInterface. For additional information, see the appropriate documentation for yourPrisma II system release.44 78-4037880-01 Rev B