Prisma II High Density EDFA Modules Installation Guide

More documents

Recommendations

Info

ContentsChapter 5 Maintenance and Troubleshooting 83Maintenance............................................................................................................................ 84Maintenance Record ................................................................................................. 84General Troubleshooting Information ................................................................................ 85Equipment Needed ................................................................................................... 85Additional Assistance .............................................................................................. 85Troubleshooting ........................................................................................................ 85Troubleshooting Alarm Conditions .................................................................................... 86EDFA Module Alarm Conditions ........................................................................... 86Chapter 6 Customer Information 87Appendix A Module Parameter Descriptions 89High Density EDFA Parameters .......................................................................................... 90Operating Status Parameters ................................................................................... 90Alarm Data Parameters ............................................................................................ 90Manufacturing Data Parameters ............................................................................ 91Configurable Parameters ......................................................................................... 91Glossary 93Index 97vi78-4037880-01 Rev B
Important Safety InstructionsImportant Safety InstructionsRead and Retain InstructionsCarefully read all safety and operating instructions before operating this equipment,and retain them for future reference.Follow Instructions and Heed WarningsTerminologyFollow all operating and use instructions. Pay attention to all warnings and cautionsin the operating instructions, as well as those that are affixed to this equipment.The terms defined below are used in this document. The definitions given are basedon those found in safety standards.Service Personnel - The term service personnel applies to trained and qualifiedindividuals who are allowed to install, replace, or service electrical equipment. Theservice personnel are expected to use their experience and technical skills to avoidpossible injury to themselves and others due to hazards that exist in service andrestricted access areas.User and Operator - The terms user and operator apply to persons other than servicepersonnel.Ground(ing) and Earth(ing) - The terms ground(ing) and earth(ing) are synonymous.This document uses ground(ing) for clarity, but it can be interpreted as having thesame meaning as earth(ing).Electric Shock HazardThis equipment meets applicable safety standards.WARNING:To reduce risk of electric shock, perform only the instructions that areincluded in the operating instructions. Refer all servicing to qualified servicepersonnel only.Electric shock can cause personal injury or even death. Avoid direct contact withdangerous voltages at all times. The protective ground connection, where provided,is essential to safe operation and must be verified before connecting the powersupply.78-4037880-01 Rev B vii
Page 1: 78- 4037880- 01 R ev BPrisma IIHigh
Page 4 and 5: NoticesTrademark AcknowledgmentsCis
Page 6 and 7: ContentsOperating Environment .....
Page 10 and 11: Important Safety InstructionsKnow t
Page 12 and 13: Important Safety InstructionsReduce
Page 14 and 15: Important Safety InstructionsEquipo
Page 16 and 17: Important Safety InstructionsTake t
Page 18 and 19: Important Safety InstructionsFCC St
Page 20 and 21: Laser SafetySafe Operation for Soft
Page 22 and 23: Laser Power and Warning LabelsLocat
Page 24 and 25: ScopeThis guide discusses the follo
Page 26 and 27: Chapter 1Module IntroductionHigh De
Page 32 and 33: Chapter 1Module IntroductionModel S
Page 34 and 35: Chapter 1Module IntroductionMaximum
Page 40 and 41: Chapter 1Module IntroductionConstan
Page 42 and 43: Chapter 1Module IntroductionSide Vi
Page 44 and 45: Chapter 1Module IntroductionConfigu
Page 46 and 47: Chapter 2Module InstallationPrepari
Page 48 and 49: Chapter 2Module InstallationSpace R
Page 50 and 51: Chapter 2Module InstallationPrisma
Page 52 and 53: Chapter 2Module InstallationPrisma
Page 54 and 55: Chapter 2Module InstallationTo Inst
Page 56 and 57: Chapter 2Module Installation2 Align
Page 58 and 59:
Chapter 2Module Installation5 Disen
Page 60 and 61:
Chapter 2Module InstallationTo Conn
Page 62 and 63:
Chapter 2Module InstallationTo Conn
Page 64 and 65:
Chapter 2Module InstallationControl
Page 66 and 67:
Chapter 3Operation using ICIMICIM I
Page 68 and 69:
Chapter 3Operation using ICIMICIM2
Page 70 and 71:
Chapter 3ICIM KeypadOperation using
Page 72 and 73:
Chapter 3Operation using ICIM3 Pres
Page 74 and 75:
Chapter 3Operation using ICIM• Th
Page 76 and 77:
Chapter 3Operation using ICIMOperat
Page 78 and 79:
Chapter 3Operation using ICIMI C I
Page 80 and 81:
Chapter 3Operation using ICIMChecki
Page 82 and 83:
Chapter 3Operation using ICIMSample
Page 84 and 85:
Chapter 3Operation using ICIMALARMS
Page 86 and 87:
Chapter 3Operation using ICIMChecki
Page 88 and 89:
Chapter 3Operation using ICIMSaving
Page 90 and 91:
Chapter 4Operation using LCILCI Int
Page 92 and 93:
Chapter 4Operation using LCIInstall
Page 94 and 95:
Chapter 4Operation using LCI5 When
Page 96 and 97:
Chapter 4Operation using LCIConnect
Page 98 and 99:
Chapter 4Operation using LCIStartin
Page 100 and 101:
Chapter 4Operation using LCILCI Mod
Page 102 and 103:
Chapter 4Operation using LCIHD-EDFA
Page 104 and 105:
Chapter 4Operation using LCIHD-EDFA
Page 106 and 107:
Chapter 5Maintenance and Troublesho
Page 108 and 109:
Chapter 5Maintenance and Troublesho
Page 111 and 112:
A Appx auto letterModule ParameterA
Page 113 and 114:
High Density EDFA Parameters* This
Page 115 and 116:
ACDEGlossaryac, ACalternating curre
Page 117 and 118:
OPQRSGlossaryNMSnetwork management
Page 119 and 120:
IndexAac, AC • 93Access Requireme
Page 121 and 122:
IndexTo Check Alarms using ICIM •
show all

Prisma II High Density EDFA Modules Installation Guide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?