Prisma II High Density EDFA Modules Installation Guide

Chapter 2Module Installation2 Align the ridges on the top and bottom of the module with the module guideslots located on the chassis.3 Gently slide the module into the chassis until its power and communicationsconnections join connectors on the midplane bus. Do not force the module into thechassis. If properly aligned, it should slide in with minimal force.4 Tighten the screw at the top of the module to secure it in the chassis. Use a 3/8-in. flat-blade screwdriver to secure. Do not over-tighten.5 Fill any unused chassis slots with module blanks to help ensure proper coolingair flow.34 78-4037880-01 Rev B