Prisma II High Density EDFA Modules Installation Guide

3 Chapter 3Operation using ICIMIntroductionThe procedures in this chapter apply if you are using the Prisma IIICIM2 front-panel interface to configure and operate the module. Forinformation on using CLI commands or the ICIM Web Interface toconfigure and operate the module, see the appropriate documentationfor your Prisma II system release.Scope of This ChapterIncluded in this chapter are descriptions of the ICIM2 front-panelkeyboard and liquid crystal display (LCD), and detailed procedureson how to use front-panel menus to configure the module.Note: You must use CLI commands or the ICIM Web Interface toconfigure and operate the module when using the ICIM2-XD. Fordetails, see the appropriate documentation for your Prisma II systemrelease.In This Chapter• ICIM Introduction ................................................................................. 44• ICIM2 Front Panel ................................................................................. 46• ICIM Password ...................................................................................... 49• Operating the ICIM .............................................................................. 54• Checking the Operating Status using the ICIM ................................ 58• Configuring the Module using the ICIM........................................... 59• Checking Module Alarms using the ICIM ........................................ 61• Checking Manufacturing Data using the ICIM ................................ 64• Saving the Configuration using the ICIM ......................................... 6678-4037880-01 Rev B 43