Prisma II High Density EDFA Modules Installation Guide

Chapter 2Module InstallationTo Install the Host Module in the ChassisNote: This procedure assumes that the chassis is mounted in a rack.1 Locate the fiber guides at the bottom of the chassis and the module guide slotsinside the chassis as shown in the following illustration.2 Align the ridges on the top and bottom of the host module with the guide slotson the chassis. Be careful to keep the host module level as you slide it into thechassis to avoid bending the pins on the back plane bus.3 Gently slide the host module into the chassis until you feel the connections onthe back of the host module join connectors on the back plane bus.32 78-4037880-01 Rev B