Prisma II High Density EDFA Modules Installation Guide

Module ConfigurationModule ConfigurationThe module is shipped from the factory with operational parameters set to factorydefaults. However, you will probably choose to configure the operating parametersso that they are best suited for your application.Configuration and Monitoring MethodsThe module may be controlled and monitored using any of the following methods. Prisma II ICIM Front PanelWhen a standard Intelligent Communications Interface Module 2 (ICIM2) isused, its front-panel LCD and keypad interface can be used to configure andmonitor this and other Prisma II modules in the ICIM domain. For instructionson operating this module using this ICIM, refer to Operation using ICIM (onpage 43). LCI SoftwareLCI software running on a locally connected PC may be used to configureoperating parameters of Prisma II modules. For instructions on operating thismodule using LCI software, refer to Operation using LCI (on page 67). CLI CommandsIf an ICIM2 or ICIM2-XD is installed, CLI commands enable communicationbetween the ICIM and the operator over Telnet to allow for remote module setupand monitoring. For details, see the appropriate documentation for your PrismaII system release. ICIM Web InterfaceThe ICIM Web Interface offers a user-friendly alternative to CLI commands forremote module setup and monitoring using an ICIM2 or ICIM2-XD. Usersnavigate a series of HTML pages through a standard web browser to view and,where permitted, adjust module parameters. For additional information, see theappropriate documentation for your Prisma II system release.78-4037880-01 Rev B 21