Prisma II High Density EDFA Modules Installation Guide

Chapter 4Operation using LCILCI IntroductionLaser WarningWARNING:• Avoid personal injury! Use of controls, adjustments, or procedures otherthan those specified herein may result in hazardous radiation exposure.• Avoid personal injury! The laser light source on this equipment (if atransmitter) or the fiber cables connected to this equipment emit invisiblelaser radiation. Avoid direct exposure to the laser light source.• Avoid personal injury! Viewing the laser output (if a transmitter) or fibercable with optical instruments (such as eye loupes, magnifiers, ormicroscopes) may pose an eye hazard. Do not apply power to this equipment if the fiber is unmated or unterminated. Do not stare into an unmated fiber or at any mirror-like surface that could reflectlight emitted from an unterminated fiber. Do not view an activated fiber with optical instruments such as eye loupes,magnifiers, or microscopes. Use safety-approved optical fiber cable to maintain compliance with applicablelaser safety requirements. Even if the unit is off, there may still be hazardous optical levels present.LCI FunctionLCI is software that functions as a user interface for the Prisma II platform. LCI isinstalled on a computer, which is then connected to a Prisma II Chassis. Using LCI,you can configure and monitor the modules in the chassis to which the computer isconnected.Important: Do not operate any Prisma II Chassis without a fan tray installed. If a fantray is not installed in the Prisma II Chassis, the LCI will not communicate with anyof the power supplies in that chassis.68 78-4037880-01 Rev B