TM9-2330-202-14&P - JATONKAM35s HOME ON THE WEB

TM 9-2330-202-14&PSection VI.ELECTRICAL SYSTEM MAINTENANCEParagraphPageNumber Paragraph Title NumberNOTEChange 2 adds the M101A1. Specific M101A1 information is contained in thischapter and designated in the chapter and section indexes.4-27 General. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-394-28 Composite Stoplight-Taillight Maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-394-28.1 Blackout Stoplight Maintenance (M101A1 and M116A1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-42.14-28.2 Stoplight Maintenance (M101A1 and M116A1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-42.64-29 Chassis Wiring Harness Replacement. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-434-30 Intervehicular Cable Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-464-31 Wiring Diagram. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-484-27. GENERAL.This section describes and illustrates removal and installation procedures for the composite stoplight-taillight,chassis wiring harness, and Intervehicular cable.4-28. COMPOSITE STOPLIGHT-TAILLIGHT MAINTENANCE.This task covers:a. Lamp/LED Removalb. Lamp/LED InstallationInitial Setup:Tools/Test Equipment:• General mechanic's tool kit (Item 1, Appendix B)Materials/Parts:• Tag, marker (as needed) (Item 16, Appendix F)• Lockwasher (2), MS35338-46c. Composite Stoplight-Taillight Removald. Composite Stoplight-Taillight Installation• Starwasher (2), MS45904-76Equipment Conditions:• Intervehicular cable disconnected from towingvehicle (para 2-15).a. LAMP/LED REMOVALNOTEBoth 12 V dc and 24 V dc lamps areavailable. If towing vehicle is aCUCV, 12 V dc lamps should beused.1. Loosen six captive screws (1), andremove lens (2) from body (3).2. Inspect preformed packing (4) for damage.If damaged, remove preformedpacking (4) and discard.3. Remove two lamps (5 and 6) from sockets(7) by pushing in and turning counterclockwise.438-066Change 2 4-39