TM9-2330-202-14&P - JATONKAM35s HOME ON THE WEB

TM 9-2330-202-14&P447. SPRING HANGER REPLACEMENT (continued).6. Remove bushing (23) from rear spring hanger (14).c. CLEANING AND INSPECTIONNOTERemove bushing only if damaged.c. CLEANING AND INSPECTIONWARNINGDrycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles and gloves,and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes, and DO NOTbreathe vapors. DO NOT use near open flame or excessive heat.1. Clean all removed components with drycleaning solvent and rag and allow to dry. Make sure lubrication passages inshackle pins are free of grease.2. Inspect all removed components for cracks, breaks, corrosion, and damaged threads. Replace if damaged.d. REAR SPRING HANGER INSTALLATION1. If removed, install bushing (23) in rear spring hanger (14).2. Install rear spring hanger (14) on frame (13) with four capscrews (22), washers (21), and new self-locking nuts (20).Torque self-locking nuts to 30 Ib-ft (41 N•m).3. Use floor jack to raise vehicle until shackle (18) is aligned with rear spring hanger (14).4. Install shackle pin (17) through shackle (18) and rear spring hanger (14).5. Install slotted nut (16) on shackle (18) and tighten. Install new cotter pin (15) on shackle (18).6. Install new lubrication fitting (19) in shackle pin (17).7. Remove support from rear comer of vehicle. Remove floor jack from under vehicle.4-95