TM9-2330-202-14&P - JATONKAM35s HOME ON THE WEB

TM 9-2330-202-14&P4-38. HYDRAULIC BRAKE ACTUATOR ASSEMBLY REPLACEMENT (continued).NOTEFor trailers with master cylinder cap, do step 8. For trailers with drain hose, do steps 9 and 10.8. Remove cap (53) and gasket (54) from master cylinder (8). Discard gasket if damaged.9. Loosen clamp (55) and remove drain hose (56) from vent tube (57).10. Remove vent tube (57), filler cap (58), baffle (59), and gasket (60) from master cylinder (8). Discard gasket ifdamaged.c. CLEANING AND INSPECTIONWARNINGDrycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles andgloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes, andDO NOT breathe vapors. DO NOT use near open flame or excessive heat.1. Clean all removed components with drycleaning solvent and rag and allow to dry. Clean boot with detergent andwater.2. Inspect all removed components for wear, breaks, cracks, damaged welds, corrosion, or other damage. Replace ifdamaged.3. Inspect breakaway lever for worn ratchet teeth. Replace if damaged.4. Remove any corrosion with a wire brush.5. Inspect for a worn slot in pushrod. Replace pushrod if slot is worn.6. Inspect for a weak or broken spring. Replace if damaged.7. Inspect shock absorber for leaks or bad rubber bushings. Replace if damaged.8. Inspect master cylinder for leaks. Replace if damaged.4-67