TM9-2330-202-14&P - JATONKAM35s HOME ON THE WEB

TM 9-2330-202-14&PI-2.SPECIFIC LUBRICATION INSTRUCTIONS (CONTINUED).e. When authorized to install new parts, remove any preservative materials, such as rust preventive compoundor protective grease, prior to installation. Apply lubricant prescribed in lubrication instructions ifrequired.f. Clean and lubricate bearings as specified in TM 9-214.g. Refer to FM 9-207 for lubrication instructions in cold weather.h. After operation in mud or in sandy or dusty conditions, clean and inspect all points of lubrication for fouledlubricants. Change lubricants as required.i. After any fording operation, lubricate vehicle in accordance with lubrication instructions.WARNINGDrycleaning solvent P-D-680 is toxic and flammable. Always wear protectivegoggles and gloves, and use only in a well-ventilated area. Avoid contactwith skin, eyes, and clothes, and DO NOT breathe vapors. DO NOT use nearopen flame or excessive heat.j. Clean all fittings and the area around lubrication points with drycleaning solvent (Item 15, Appendix F) orthe equivalent before lubricating equipment. After lubrication, wipe off excess oil grease to preventaccumulationof foreign matter.I-3.LUBRICATION CHART.a. The Lubrication Chart covers lubrication points for the M101A1, M101A2 and M101A3 two-wheel, 3/4-toncargo trailers; the M116A1, M116A2 and M116A2E1 two-wheel, 3/4-ton chassis trailers; and the M116A3two-wheel, 1-ton chassis trailer. The lubrication points shown are for all models unless otherwise noted.b. Intervals (on-condition or hard time) and related man-hour times are based on normal operation. The manhourtime specified is the time you need to do all the services prescribed for a particular interval. Decreasethe intervals if your lubricants are contaminated or if you are operating equipment under adverse conditions,including longer than usual operating hours. The intervals may be extended during periods of lowactivity. If extended, adequate preservation precautions must be taken.c. The lowest level of maintenance authorized to lubricate a point is indicated In parentheses by use of thefollowing: (C) Operator/Crew or (O) Unit maintenance.I-2 Change 2