TM9-2330-202-14&P - JATONKAM35s HOME ON THE WEB

TM 9-2330-202-14&P4-43.1. HUB, BRAKEDRUM, AND WHEEL BEARINGS MAINTENANCE (M101A1 ANDM116A1) (CONTINUED).2. Place wheel hub and brakedrum assembly (9) on work bench.3. Remove three screws (13).4. Screw three retaining cap screws (14) evenly into tapped holes (15) to drive out wheel hub (16) frombrakedrum (17).5. Place wheel hub (16) on work bench. If damaged, drive out five shoulder bolts (18) and discard.438-006c. CLEANING AND INSPECTIONWARNING• Wear an approved filter mask and gloves. NEVER use compressed air or a drybrush to clean brake components. Dust may be removed using an industrialtypevacuum cleaner. Clean dust or mud away from brake components withwater and a wet, soft brush or cloth. Failure to follow this warning may result inserious illness or death to personnel.• Drycleaning solvent P-D-680 is toxic and flammable. Always wear protectivegoggles and gloves, and use only in a well-ventilated area. Avoid contact withskin, eyes, and clothes, and DO NOT breathe vapors. DO NOT use near openflame or excessive heat.1. Clean and inspect inner and outer bearing hub cones and rollers in accordance withTM 9-214. If any cone or roller needs replacing, all cones and rollers must be replaced.2. Clean all other removed components with drycleaning solvent and rag and allow to dry.4-90.2 Change 2