G1000 Reference Guide - SkyHoppers

SECTION 8 – FLIGHT PLANNING5) For point-to-point planning, turn the FMS Knobsto enter the identifier of the starting waypoint.Once the waypoints identifier is entered, pressthe ENT Key to accept the waypoint. The flashingcursor moves to the ending waypoint. Again,turn the FMS Knobs to enter the identifier of theending waypoint and press the ENT Key to acceptthe waypoint. OR,6) For flight plan leg planning, press the FPL Softkey(at the bottom of the display) and turn the smallFMS Knob to select the desired flight plan (alreadystored in memory), by number. Turn the large FMSKnob to highlight the ‘LEG’ field and turn thesmall FMS Knob to select the desired leg of theflight plan, or select ‘CUM’ to apply trip planningcalculations to the entire flight plan. Selecting‘FPL 00’ will display an active flight plan. If anactive flight plan is selected, ‘REM’ will be anavailable option to display planning data for theremainder of the flight plan.9) Turn the FMS Knobs to enter the fuel flow.Press the ENT Key when finished. Note that inautomatic page mode, fuel flow is provided bythe system.10) The flashing cursor moves to the fuel on boardfield. Turn the FMS Knobs to modify the fuelon board. Press the ENT Key when finished. In‘AUTOMATIC’ mode, fuel onboard is provided bythe entry made in ‘GAL REM’ on the EIS SystemPage.11) The flashing cursor moves to the calibratedairspeed field. Turn the FMS Knobs to enter acalibrated airspeed. Press the ENT Key whenfinished.NOTE: The Page Mode must be set to MANUALto perform the following steps.7) Turn the large FMS Knob to highlight thedeparture time (DEP TIME) field.NOTE: The departure time on the Trip PlanningPage is used for preflight planning. Refer to theUtility Page for the actual flight departure time.8) Turn the FMS Knobs to enter the departure time.Press the ENT Key when finished. (Departure timemay be entered in local or UTC time, dependingupon system settings).190-00384-07 Rev. A Garmin G1000 Cockpit Reference Guide for the Cessna Nav III8-9