G1000 Reference Guide - SkyHoppers

SECTION 9 – PROCEDURESSECTION 9: PROCEDURES9.1 ARRIVALS AND DEPARTURESLoad and Activate a Departure Procedure1) Press the PROC Key.2) Turn the large FMS Knob to highlight ‘SELECTDEPARTURE’.3) Press the ENT Key.4) If a flight plan is active, the departure airport willbe displayed as the default. A list of availabledepartures is also displayed. If no flight plan isactive, use the FMS Knobs to enter the identifierof the desired airport. Press the ENT Key.5) Turn the large FMS Knob to highlight theDeparture field. Turn the small FMS Knob todisplay a list of available departures.6) Turn either FMS Knob to select the desireddeparture and press the ENT Key.Figure 9-1 Select Departure7) A list of runways may be displayed for thedeparture. Turn either FMS Knob to select thedesired runway and press the ENT Key.8) A list of available transitions is displayed for thedeparture. Turn either FMS Knob to highlight thedesired transition waypoint and press the ENTKey.Figure 9-2 Select Departure Transition9) With ‘LOAD?’ highlighted, press the ENT Key. Thedeparture will be active when the flight plan isactive.Load and Activate An Arrival ProcedureNOTE: If any portion of an arrival procedure isthe active leg of a flight plan, the existing arrivalprocedure must be deleted before changing to adifferent arrival procedure.1) Press the PROC Key.2) Turn the large FMS Knob to highlight ‘SELECTARRIVAL’.3) Press the ENT Key.4) If a flight plan is active, the destination airportwill be displayed as the default. A list of availablearrivals is also displayed. If no flight plan is active,use the FMS Knobs to enter the identifier of thedesired airport. Press the ENT Key.5) Turn the large FMS Knob to highlight the Arrivalfield. Turn the small FMS Knob to display a listof available arrivals.6) Turn either FMS Knob to select the desired arrivaland press the ENT Key.190-00384-07 Rev. A Garmin G1000 Cockpit Reference Guide for the Cessna Nav III9-1