G1000 Reference Guide - SkyHoppers

SECTION 7 – NAVIGATIONFigure 7-5 Recently Entered Waypoints List (MFD)3) Turn the small FMS Knob to the right to displaythe ‘RECENT’ waypoints as shown in Figure 7-5.4) Turn the large FMS Knob to select the desiredairport.5) Press the ENT Key. The cursor is now displayedon ‘ACTIVATE?’.6) Press ENT again to activate a Direct-to.Re-center the CDI to the DestinationWaypointPress the Direct-to ( ) Key, followed bypressing the ENT Key twice. If a missed approachpoint (MAP) is the current destination, theapproach will be canceled.Manually Define the Active Direct-to1) Press the Direct-to ( ) Key.2) Turn the large FMS Knob to highlight the ‘VNAV’altitude field.3) Enter the desired altitude.4) Press the ENT Key. The option to select ‘MSL’ or‘AGL’ is now displayed.5) Turn the small FMS Knob to select ‘MSL’ or‘AGL’.6) Press the ENT Key. The cursor now highlights theVNAV offset field.7) Enter the desired offset distance.8) Press the ENT Key.9) Turn the large FMS Knob to place the cursor inthe ‘COURSE’ field.10) Enter the desired course.11) Press the ENT Key. The cursor now highlights‘ACTIVATE?’.12) Press the ENT Key again to begin navigation usingthe selected destination, altitude constraint, andcourse.Canceling Direct-to Navigation1) Press the Direct-to ( ) Key.2) Press the MENU Key to display the Direct-tooptions menu.3) With ‘Cancel Direct-To NAV’ highlighted, pressthe ENT Key. If a flight plan is still active, theG1000 resumes navigating the flight plan alongthe closest leg.Figure 7-6 Canceling Direct-to NavigationDirect-to Navigation from the PFDIdentifierFacility NameVNAV Target AltitudeBearing to WPTCourse to Selected WPTWPT SymbolFigure 7-7 PFD Direct-to WindowWPT LocationOffset DistanceDistance from WPT190-00384-07 Rev. AGarmin G1000 Cockpit Reference Guide for the Cessna Nav III7-3