G1000 Reference Guide - SkyHoppers

SECTION 1SYSTEM OVERVIEWGPS – Displays GPS waypoint identifier and GPSdistance information in the BRG2 InformationWindow.ADF – Displays ADF in the BRG2 InformationWindow.OFF – Removes the BRG2 InformationWindow.ALT UNIT – Displays softkeys for setting thealtimeter and BARO settings to metric units:METERS – When enabled, displays altimeter inmeters.IN – Press to display the BARO setting as inchesof mercury.HPA – Press to display the BARO setting ashectopacals.STD BARO – Press to set the barometric pressureto standard pressure.BACK – Press to return to the previous level softkeys.ALERTS – Press to display the Alerts Window.OBS – Press to select OBS Mode on the CDI whennavigating by GPS (only available with active leg).CDI – Press to change navigation mode on the CDIbetween GPS, VOR1, and VOR2.DME (optional) – Press to display the DME TuningWindow.XPDR – Press to display the transponder modeselection softkeys.STBY – Press to select Standby Mode.ON – Press to select Mode A.ALT – Press to select Altitude Reporting Mode.GND – Press to select Ground Mode.VFR – Press to automatically squawk 1200 (onlyin the U.S.A., refer to ICAO standards for VFRcodes in other countries).CODE – Press to display transponder code selectionsoftkeys 0-7.0 through 7 – Press numbers to enter code.IDENT – Press to provide special aircraftposition identification to Air Traffic Control(ATC).BKSP – Press to remove numbers entered oneat a time.BACK – Press to return to the previous levelsoftkeys.IDENT – Press to provide special aircraft positionidentification to Air Traffic Control (ATC).BACK – Press to return to the previous levelsoftkeys.ALERTS – Press to display the Alerts Window.DMEALERTSALERTSPress the BACK Softkey to returnto the top-level softkeys.ALERTSFigure 1-5 XPDR (Transponder) SoftkeysPress the IDENT or BACK Softkey to returnto the top-level softkeys.190-00384-07 Rev. A Garmin G1000 Cockpit Reference Guide for the Cessna Nav III1-7