G1000 Reference Guide - SkyHoppers

SECTION 12 – ANNUNCIATIONS& ALERTSGIA 63W Message Advisories (Cont.)MessageNAV1 RMT XFR – NAV1 remotetransfer key is stuck.NAV2 RMT XFR – NAV2 remotetransfer key is stuck.G/S1 FAIL – G/S1 is inoperative.G/S2 FAIL – G/S2 is inoperative.G/S1 SERVICE – G/S1 needs service.Return unit for repair.G/S2 SERVICE – G/S2 needs service.Return unit for repair.CommentsThe remote NAV1 and/or NAV2 transfer switch is stuck in the enabled (or“pressed”) state. Press the transfer switch again to cycle its operation. If theproblem persists, the G1000 system should be serviced.A failure has been detected in glideslope receiver 1 and/or receiver 2. TheG1000 system should be serviced.A failure has been detected in glideslope receiver 1 and/or receiver 2. Thereceiver may still be available. The G1000 system should be serviced whenpossible.GEA 71 Message AdvisoriesMessageGEA1 CONFIG – GEA1 configurationerror. Config service req’d.MANIFEST – GEA1 softwaremismatch. Communication halted.MANIFEST – GEA2 softwaremismatch. Communication halted.CommentsThe GEA1 configuration settings do not match those of backup configurationmemory. The G1000 system should be serviced.The #1 GEA 71 has incorrect software installed. The G1000 system should beserviced.The #2 GEA 71 has incorrect software installed. The G1000 system should beserviced.GTX 33 Message AdvisoriesMessageXPDR1 CONFIG – XPDR1 config error.Config service req’d.MANIFEST – GTX1 softwaremismatch. Communication halted.XPDR1 SRVC – XPDR1 needs service.Return unit for repair.XPDR1 FAIL – XPDR1 is inoperative.CommentsThe transponder configuration settings do not match those of backupconfiguration memory. The G1000 system should be serviced.The transponder has incorrect software installed. The G1000 system should beserviced.The #1 transponder should be serviced when possible.There is no communication with the #1 transponder.12-18Garmin G1000 Cockpit Reference Guide for the Cessna Nav III190-00384-07 Rev. A