Alibre Design

Chapter 7 - Feature Creation7.1 The Part Modeling InterfaceThe Part Modeling toolbar is shown by default on the right side of the workspace.Extrude Boss . . . create an extrude boss featureExtrude Cut . . . create an extrude cut featureRevolve Boss . . . create a revolve boss featureRevolve Cut . . . create a revolve cut featureLoft Boss . . . create a loft boss featureLoft Cut . . . create a loft cut featureSweep Boss . . . create a sweep boss featureSweep Cut . . . create a sweep cut featureHelical Boss ... create a helical boss featureHelical Cut ... create a helical cut featureDesign Boolean . . . create Boolean featureTrim Model . . . trim a model with respect to a reference surfaceThicken Surface . . . thicken a reference surfaceFillet . . . create a fillet featureEdge Chamfer . . . create an edge chamfer featureShell . . . create a shell featureDraft Surface . . . create a draft surface featureHole . . . create a hole featureInsert Catalog Feature ... insert a feature that you previously savedEquation Editor . . . open the Equation EditorRegenerate . . . regenerate the part to update changes158