Alibre Design

Chapter 7 - Feature Creation2. Make sure that the Sketch field is populated with the sketch you want to extrude.3. Select a Type from the pull down menu. Follow the steps below depending on theType.To Depth, Mid Plane, Through All extrusionsTo Depth - Creates an extrusion of a specified depth on one side of the sketchplane.Mid Plane - Creates an extrusion of a specified depth on both sides of thesketch plane. Half the extrusion length is proportional to each side of thesketch plane.Through All - Applies only to extrude cut. Creates the cut through the entiresolid in the specified direction.a. Specify the extrusion Depth value. If using To Depth, you can select theReverse option if necessary to create the extrusion on the opposite side of thesketch plane.b. Note: When using the To Depth or Mid Plane options, you can dynamicallyresize the extrusion in the work area by dragging the node associated with thesketch profile. As you drag the node, the extrusion length will automaticallyincrease or decrease increments based on the Spinner Increment value (File> Properties > Units tab).161