Carriers

Technical Data — UNIFLEX Series
Type 0600
Divider systems
Divider system TS 0
without height subdivision
Version A Version B
s T 3 mm 3 mm
a T min 4.1 mm
a x min 8.2 mm 4 mm
a x grid continuous 10 mm
The divider system can be planned by you or by our engineers on the
basis of the information you supply about the configuration of the
cable carrier.
As standard, the divider system is fitted on every frame stay
(with stay assembly on every second chain link).
In version A the dividers can slide along the chain cross section.
In version B the dividers can be fixed at intervals of 10 mm.
Please state the number of
dividers/cross section n T when ordering.
Sample order:
Divider system TS 0/n T 3
a TL a x
s T a TR
B i
KR
Divider system TS 1
with continuous height subdivision
Height subdivision: Al-Profile 11 x 4 mm
VD 1
VD 2
VD 4
VD 3
VD 4
VD 23
VD 43
20
20
4
2
1
3
5
14
28
KR
13
27
6
34
13 27
34
6
13 10 13
6
17
13
a TL a
a x
sT TR
B i
Position of the
sub-division(s)
in the divider
Version A Version B
s T 3 mm 3 mm
a T min 4.1 mm
a x min 8.2 mm 4 mm
a x grid continuous 10 mm
n T min 2 2
Technically recommended variants: VD 1, VD 2 and VD 3
The dividers can slide along the chain cross section!
Please state the type of height
subdivisions and the number of
dividers/cross section n T when ordering.
Sample order:
Divider system TS 1– VD 2/n T 5
3.144 Subject to technical changes! UNIFLEX