Carriers

Technical Data - QUANTUM-Series
Type Q060
Divider systems
for Stay variant “RS“
The divider system can be planned by you or by our engineers on the
basis of the information you supply about the configuration of the
cable carrier.
As standard, the divider system is fitted on every frame stay (with stay
assembly on every 6th pitch division).
Divider system TS 0
without height subdivision
s T = 3 mm
a T min = 13.5 mm
a x min = 13 mm
38
Please state the number of
dividers/cross section n T when ordering.
Sample order:
Divider system TS 0/n T 4
s
a a T
T x a T
B i
The dividers can slide along the chain cross section!
KR
Divider system TS 1
with continuous height subdivision
Height subdivision: Al-Profile 11 x 4 mm
Technically recommended variant: VD 1
The dividers can slide along the chain cross section!
s T = 3 mm
a T min = 13.5 mm
a T max = 40 mm
a x min = 13 mm
n T min = 2
Please state the type of height subdivision
and the number of dividers/cross
section n T when ordering.
Sample order:
Divider system TS 1 – VD 1/n T 4
a T
VD 1
17
2
1
3
a
s T x a T
B i
17
VD 2
24.5 9.5
VD 3
24.5
9.5
VD 23
9.5 11 9.5
KR
15
Position of the
sub-division(s)
in the divider
Divider system TS 2
with grid subdivision (1 mm grid)
Height subdivision: Al-Profile 11 x 4 mm
Technically recommended variants: VD 0 and VD 1
Dividers fixed by height subdivision, the grids can slide along
the chain cross section!
s T = 6 mm
a T min = 13.5 mm
a x min = 13mm(with height subdivision)
a x min = 13 mm (at VR 0)
a x grid = Continuous
n T min = 2
Please indicate the cavities (from left to
right), the relevant subdivision variant
and the assembly spacing a T and a x
when ordering.
Sample order: Divider system TS 2
K(cavity) 1- VR 0 / 20 mm
K 2 - VR 1 / 50 mm
K 3 - VR 0 / 60 mm
K 4 - VR 1 / 40 mm
K 5 - VR 0 / 20 mm
VR 0
38
a TL
VR 1 VR 2 VR 3 VR 23
17 17
9.5
9.5 24.5
9.5
2
1
3
s
a T
Position of the
x1 ax2 a TR
sub-division(s)
B i in the divider
24.5
11
9.5
VR 0
38
KR
15
4.08 Subject to technical changes! QUANTUM