Carriers

Technical Data — M Series
Type MK 0475
Divider system
for opening variant 01 and 02
The divider system can be planned by
you or by our engineers on the basis of
the information you supply about the
configuration of the cable carrier.
As standard, the divider system is fitted
on every 2nd chain cross section!
Divider system TS 0
without height subdivision
Version A Version B
s T 2.8 mm 2.8 mm
a T min 6 mm 12 mm
a x min 7.8 mm 8 mm
a x grid continuous 8 mm
With Version B a x must be divisible by 8!
Please state the number of
dividers/cross section n T when ordering.
Sample order:
Divider system TS 0 – A / n T 4
Divider system TS 1
with continuous height subdivision
Height subdivision: Al-Profile 6 x 2.4 mm
Version A Version B
s T 2.8 mm 2.8 mm
a T min 6 mm 12 mm
a T max 20 mm 20 mm
a x min 7.8 mm 8 mm
a x grid continuous 8 mm
n T min 2 2
With Version B a x must be divisible by 8!
Please state the type of height
subdivisions and the number of
dividers/cross section when ordering.
Sample order:
Divider system TS 1-B – VD 1 / n T 4
a TL a x1
s T
a TR
B i
Dividers can slide along the cross-section (Version A) or are fixed
(Version B). For divider version B please state fitting intervals
a T and a x !
12.8
5.3
20.3
5.3
12.6
5.3
a TL a x1 a TR
subdivision(s)
2
1
3
s T
Position of the
a x2
B i
in the divider
12.8
Version A
Notch in connecting
profile to the inside
(Standard)
The dividers can slide
along the section.
VD 1 VD 2 VD 3 VD 23
20.3
5.3
Dividers can slide along the cross-section (Version A) or are fixed
(Version B). For divider version B please state fitting intervals
a T and a x !
28
Technically recommended variants: VD 1
Version B
Notch in connecting
profile to the outside
The dividers are fixed
in the section
(a x -grid 8 mm)
KR
KR
15
Divider system TS 2
with grid subdivision
Height subdivision: Al-Profile 6 x 2.4 mm
s T
a T min
a x min with subdivision
a x min at VR 0
a x grid
Version B
2.8 mm
12 mm
24 mm
8 mm
8 mm
With Version B a x must be divisible by 8!
Please indicate the cavities (from left
to right), the relevant subdivision variant
and the assembly spacing a T and a x
when ordering.
Sample order:
Divider system TS 2-B
K(cavity) 1 - VR 0 / 12 mm
K 2 - VR 3 / 32 mm
K 3 - VR 1 / 40 mm
VR 0 VR 1 VR 2 VR 3 VR 23 VR 0
28
12.8
12.8
MK Subject to technical changes! 3.509
5.3
20.3
B i
20.3
5.3
5.3
12.6
5.3
a TL a x1 s T
a TR
KR
2
1
3
Position of the
subdivision(s)
in the divider
Grid segments are as a rule fixed in the chain cross-section (Version B)!
15