Carriers

Technical Data — K Series
Type KE 0900
Divider systems
The divider system can be planned by you
or by our engineers on the basis of the
information you supply about the configuration
of the cable carrier.
As standard, the divider system is fitted on
every frame stay (with stay assembly on
every 2nd chain link).
Version A
Notch in connecting
profile to the inside
(Standard)
The dividers can slide
along the section.
Version B
Notch in connecting
profile to the outside
The dividers are
fixed in the section
(a x -grid 16 mm)
Divider system TS 0
without height subdivision
Dividers can slide along the cross-section (Version A) or are fixed
(Version B). For divider version B please state fitting intervals
a T and a x !
Version A Version B
s T 6 mm 6 mm
a T min 7.5 mm 8.5 mm
a x min 14.5 mm 16 mm
a x grid continuous 16 mm
With version B a x must be divisible
by 16!
Please state the type and the
number of dividers/cross section n T
when ordering.
For version A dividers with s T = 4 mm
are also available.
Sample order:
Divider system TS 0-A / n T 3
a TL
58
a x
B i
sT
a TR
KR
Divider system TS 1
with grid subdivision (1 mm grid)
Height subdivision: Al-Profile 11 x 4 mm
Technically recommended variants: VR 1, VR 4, VR 5 and VR 45
Dividers can slide along the cross-section (Version A) or are fixed
(Version B). For divider version B please state fitting intervals
a T and a x !
6
4
1 2
5 3 7
a TL a sT a TR Position of the
x
sub-division(s)
B i
in the divider
27
27
16
38
38
16
16
11
16
16
7
7
16
KR
22
Version A Version B
s T 6 mm 6 mm
a T min
24.5 mm
a T max 25mm 24.5 mm
a x min 14.5 mm 16 mm
a x grid continuous 16 mm
n T min 2 2
Please indicate the cavities (from left to right), the relevant
subdivision variant and the assembly spacing a T and a x
when ordering.
For version A dividers with s T = 4 mm are also available.
Sample order: Divider system TS 1– VD 55/n T 5
3.310 Subject to technical changes! KE